julien.morris.personal
julien.morris.personal Hey- Do you know if this will work on Linux with bCNC ?
Q: is it powerful enough to cut through 20mm xps board ? I would like to use it in cutting shapes
Asked by benossa2 on 2018-12-05 09:23:15
julien.morris.personal I would doubt that - I use it to cut 3.6 mm ply - thats at 3mm per second at .5 and 1 mm depth.
2019-06-20 11:17:45 Helpful (1)Q: What sort of cutting power does it have? Will it cut thin plywood?
Asked by Andras7 on 2019-04-02 06:36:56
julien.morris.personal Yes- it will cut 3.6mm ply - slowly ! You'll need two passed at 3mm per second feed rate, first cut a .5mm, second at 1mm. I've done lots of that. You'll need to ensure the ply is flat, it's not very forgiving - I assume that's because the focal length is small.
2019-06-19 01:47:00 Helpful (0)
We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
