daveneky@email.cz
daveneky@email.cz One note check connection ribon cable on the board accordin to this link: https://goo.gl/PoGg1T
daveneky@email.cz One note check connection ribon cable on the board accordin to this link: https://goo.gl/PoGg1T
Q: I am sorry but I am not able to bind it with Q X7. Is there some advice how make it succesfully?
Asked by daveneky@email.cz on 2017-12-22 04:28:56
Lalomendez Hello, first you need to configure receiver mode D16, in the page setup and start binding. In the receiver there is a little button in the corner (very hidden), you must press it while connect the power supply, in this moment two small led will power on (red and yellow). Disconnect the power supply from drone and exit from binding mode. Connect again the drone. Sorry for my bad english. NOTE: The trick is the binding button almost hidden in the receiver. Cheers.
2017-12-29 05:29:51 Helpful (0)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
Bison008can they have a protective coating on both sides. being led they dont get warm at all
2021-10-13 11:30:06 Helpful (0)