slimlim
My Contents
All Messages
Reviews
Comments
Answers
Questions

All Messages

slimlim Notso much a problem with the electronics, but with a short antenna the body of the quad can get in the way when you turn

BG502556513 12/11/2021
Good quality antenna with a long tube to lift the antenna up and away from your quad, in my mind (please comment and correct me if I'm wrong or confirm if I'm right) this helps stop interference from the electronics and from the quad body or battery interfering if the quad is at an angle to block it while looping etc? Anyway have had good experiences with these and this was not my first purchase as I came back for more!
1PC/2PCS/3PCS HGLRC Long Range Hammer Mini RHCP/LHCP 5.8G 2.5dBi Super Mini FPV Antenna For FPV Racing RC Drone
₹942.32 ₹1,336.74
0
Comments (1)
slimlim 08/04/2022
Working as expected so far with lots of options for connectivity, in many cases you can use either the solder pads or plugs. The plug sockets seem like they might be aimed at newbies but they also tidy things up with less wires knocking around above the board & obviously make maintenance much easier, an added bonus is the bottom of the board is well protected from shorting against the ESC with all that plastic in the way... It comes with a good selection of SH1.0 wires/connectors that are labelled & pre-wired for the FC's pinouts.
30.5x30.5mm MAMBA EASY F722 F7 MK1 3-6S Flight Controller OSD BEC for RC Drone FPV Racing
₹3,943.33
1
Recommendations
Comments (0)
slimlim 08/04/2022
Nice clean ESC, it's not a true stm32 chip (shortages) but seems to work well enough with no issues so far. The included capacitor is a low cost China brand, they seem to be rated well but I wouldn't know if it's any better than the more common options. Comes with a legit XT60, FC cables & a range of gummies for softmounting.
MAMBA 128K F40 F45 F55 F65 40A 45A 55A 65A Blheli_32 4IN1 Brushless ESC for FPV RC Racing Drone
₹5,057.99
0
Recommendations
Comments (1)

slimlim Swapped the stock capacitor for a 1000uf Panasonic FM, much better...

slimlim 08/04/2022
Nice clean ESC, it's not a true stm32 chip (shortages) but seems to work well enough with no issues so far. The included capacitor is a low cost China brand, they seem to be rated well but I wouldn't know if it's any better than the more common options. Comes with a legit XT60, FC cables & a range of gummies for softmounting.
MAMBA 128K F40 F45 F55 F65 40A 45A 55A 65A Blheli_32 4IN1 Brushless ESC for FPV RC Racing Drone
₹5,057.99
0
Comments (1)
30.5x30.5mm MAMBA EASY F722 F7 MK1 3-6S Flight Controller OSD BEC for RC Drone FPV Racing
₹3,943.33

Q: Will this work with a SucceX-E 45A 2-6S BLHeli_S 4-in-1 ESC?

Asked by ItsRagnarok on 2022-03-18 08:56:46

slimlim It will work with any ESC as long as you wire the connector properly

2022-03-22 09:08:10 Helpful (1)
Submit
Answers (2)
slimlim 06/01/2022
Everything working as expected & no issues, it's my first keyboard of this type so have nothing to compare it to but am happy with the purchase. It sounded rather scary & unappealing at first, the keycaps were loose-ish fitting & made some high frequency noise when just touching/wobbling them. I also got some razer phantom keycaps (to swap to a UK layout) which are a tighter fit, the sound & feel is much nicer. Overall it's much better than my previous cheapo low profile membrane keyboard & my typing speed has improved even though I'm still getting used to the layout & full sized key height. Obviously the thing to do it mess around with the stabilisers then start applying bits of plasters & foam to the internals, so I will probably do that at some point but will be skipping the coiled USB cable.
Royal Kludge RK84 Mechanical Keyboard 84 Keys Triple Mode Wireless bluetooth5.0 + 2.4Ghz + Type-C Wired Hot-swappable RK Switch USB Hub Rechargeable RGB Backlit ABS Keycaps Gaming Keyboard
₹6,601.37 ₹7,373.06
0
Recommendations
Comments (0)
slimlim 01/07/2019
Good airflow for parts cooling, much more than my stock Wanhao i3 fan. It's a little loud at full power & makes even louder PWM noise/screeching when throttled back too much (I didn't get this with the stock fan), it also needs a fair kick to get it going. It may run better at a PWM frequency different to the stock fan, not sure yet.
24V DC 0.1A 50mm*50mm*15mm Blow Radial Cooling Fan For 3D Printer
₹192.06 ₹342.12
4
Recommendations
Comments (1)
slimlim 06/09/2020
It's a nice little kit. The connectors were installed upside down on the LCD display I received, to get it working I had to insert both IDE cables the other way around (cut a tab in the LCD display's connectors with a hot knife) & insert them the right way up in the mainboard. I had another issue with the order but Banggood quickly resolved this, they're very reliable!
MKS GEN V1.4 Mainboard Motherboard+ 12864 LCD Display Screen + 5x A4988 Driver + 6x Limit Switch Kit For 3D Printer
₹4,130.25 ₹6,429.88
1
Recommendations
Comments (0)
slimlim 03/12/2020
Pretty nice, I'm not disappointed at all but some top of the keyway tensioners would have also been a good addition They're relatively smooth & strong, better than a lot of the other cheaper generic pick sets out there where the metal can seemingly be too thick, rough or bendy. You get loads of hooks & only one rake so these are suitable for someone wanting to do single pin picking but they should be more useful for this than what comes with some of the cheaper more extensive sets.
DANIU 12Pcs Lock Picks Tools Set Lock Opener Locksmith Tools Various Transparent Locks Combination, Locksmith Tools Kit
₹1,909.50 ₹2,228.47
0
Recommendations
Comments (0)
LONG-CZ J9 0.66 Inch 300mAh Smallest Flip Phone bluetooth Dialer FM Magic Voice Handsfree Earphone Mini Card Phone
₹2,433.39 ₹3,857.59

Q: Anyone have any recommendations over which of these tiny phones provide the best mix of comfort & features?

Asked by slimlim on 2020-10-26 11:16:35

Qtsley mini card Phone is spare mobile phone, easy to carry, isolated social, but can make basic communication functions such as calling and sending SMS,you can search those:https://www.banggood.com/Wholesale-Mini-Card-Phones-c-11060.html

2020-10-31 03:02:44 Helpful (0)
Submit
Answers (1)
slimlim 11/09/2020
No issues with MKS Gen 1.4 board in legacy mode, very quiet & definitely a useful upgrade over A4988 drivers
Geeetech® 4PCS Ultra-quiet TMC2208 Stepper Motor Driver + Heatsink + Screwdriver Kit For 3D Printer
₹2,701.77 ₹3,857.59
0
Recommendations
Comments (0)
slimlim 11/09/2020
No issues with MKS Gen 1.4 board in legacy mode, very quiet & definitely a useful upgrade over A4988 drivers
TMC2208 Stepping Motor Mute Built-in Driver Replace TMC2100 For 3D Printer
₹498.17 ₹942.32
0
Recommendations
Comments (0)
slimlim 11/07/2020
Frame isn't entirely rigid but that's fine, it's weight is at the lower end for cinewhoops so is easy to power & good for stuff that requires a lower loaded craft (indoor flight etc). Flies nicely & is a decent quality kit, not getting any oscillations or frame resonance issues. Carbon is cut well for the price & tolerances are ok. The ducts are strong enough for bumping off stuff & light crashes, likely wont take a full speed smash but that's not the nature of how these things fly anyway. It has the weird yaw bobbles & other oddities of ducted craft but isn't too bad compared to some frames, has decent yaw authority. Almost does a bit of acro reasonably well (1606 emax motors) especially with no HD cam but is draggy...
Reptile CLOUD-149HD 149mm Wheelbase 3 Inch Racing Frame Kit Compatible DJI Digital FPV System
₹2,883.54 ₹4,029.07
0
Recommendations
Comments (0)
slimlim 11/07/2020
Great, nice stack at a decent price. Comes with some stuff.
MAMBA F405 Mini MK2 Betaflight F4 Flight Controller & F30 30A / 25A 3-4S DSHOT600 FPV Racing Brushless ESC 20×20mm for RC Drone FPV Racing
₹6,001.17 ₹6,858.60
0
Recommendations
Comments (0)
slimlim 11/07/2020
Nice smooth motors, flying clean & very happy so far. Using them on a reptile cloud cinewhoop.
EMAX 1606 RS1606 3300KV 4000KV Brushless Motor 3-4S For RC Drone FPV Racing Multi Rotor
₹1,227.84 ₹1,971.24
0
Recommendations
Comments (0)
slimlim 29/04/2020
Good stuff, as expected
6mm Braided Expandable Auto Wire Cable Sleeving High Density Sheathing
₹300.10 ₹513.60
0
Recommendations
Comments (0)
slimlim 29/04/2020
Nice little charger for the price & has worked well so far, the capacitive buttons are quite non tactile but you get used to them. It has some nifty added features & the lipo charging programming seems quick & effective. All in pretty pleased
ToolkitRC M6 V2 DC 150W 10A LCD 2-6S Lipo Battery Smart Balance Charger Discharger With Voltage Servo Checker Receiver Signal Tester Quick Charger Function
₹2,429.96 ₹3,857.59
0
Recommendations
Comments (0)
slimlim 21/03/2020
Super engines for making fly very special, I like this. Construction is pretty decent for a budget motor too, they all run nice & smooth.
4PCS Emax ECO Series 2207 2400KV 3-4S Brushless Motor for RC Drone FPV Racing
₹3,986.20 ₹5,400.96
1
Recommendations
Comments (0)
slimlim 22/10/2019
It has poor light handling outdoors, everything goes really black when you point it anywhere near the sun but seems to work fine indoors. The stock UK65 cam is far better in this regard but this should be ok on an indoor whoop
Eachine TX06 700TVL FOV 120 Degree 5.8Ghz 48CH 25mW Smart Audio Mini FPV Camera Support Pitmode AIO Transmitter For RC Drone Tiny Whoop
₹2,571.44 ₹4,835.06
1
Recommendations
Comments (0)
slimlim 17/07/2019
Bit less thrust on my UK65 than the stock prop but have a nice flight feel to them & I think they bog down the motors less making it a bit easier to pull out of dives without loosing yaw authority as easily.
4 Pairs Gemfan 1219 31mm 0.8mm Hole 3-blade Propeller for 0703-1103 RC Drone FPV Racing Brushless Motor
₹599.34 ₹942.32
0
Recommendations
Comments (0)

You are the expert,can you help?

We sincerely invite you to subscribe to the Invite Answer email!

If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.

Help others and be happier!

  • Subscribe

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.Specific people will also have their own exclusive badge.
CEO Badge

The CEO Badge is owned only by the boss of Banggood.

Badges you can earn are coming soon
  • OK

About Badges

Badges are related to the community, and users earn badges by creating quality content, completing missions, or by participating in special activities.

Helpful Badges

The Badge is awarded to users who are subscribed to the Invite Answer email and signifies their gratitude to help others. The badge appearance upgrades as the user helps more people.
  • OK

Thank you for subscribing! You have also earned a badge!

  • View It

Thank you! Your answer will help ###name### and ###num### other people!

Check awaiting answers to see more people who need help.

  • OK

Thank you! Your answer will help ###name### and ###num### other people!

Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!

  • Subscribe

Are you ready to help?

We invite you to subscribe to our Invite Answer email!

Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.

  • Subscribe