Bvelinov
Q: How to set up GPS to go home
Asked by Bvelinov on 2023-04-12 03:49:32
BG181724341 There is a little setup-box with three potentiometers which must be attached to the Kopilot and the most right potentiometer must be set to 4 o'clock with a little screw driver, e.g. to the most right position. Then channel 5 of your remote control must be assigned to a 3-pos switch. When ch5 sends "-100" then Kopilot will work in RTH mode. Of course the GPS antenna must be attached and must see any satellite - this might take a while. If set correctly, the red LED in the group of three LEDs is on (GPS attached + locked). If the same LED blinks, it's connected but has not found any Satellite yet. If it's off, no GPS is connected. See also the ZOGH Kopilot Manual www[.]zohd[.]net --> Support --> Kopilot Lite
2023-04-13 01:18:35 Helpful (2)
evman8 It depends of the antennas that you will use in both RX and TX.
2023-03-07 07:30:51 Helpful (1)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
