Sezai Mahmud Hepsev
masato Normally, the battery terminal is on the rear side. You can use it in the direction you want to use, and after that, it corresponds by replacing the signal cable
2021-02-21 08:20:07 Helpful (0)Q: is it compatible with taranis q X7 also?
Asked by Sezai Mahmud Hepsev on 2020-07-09 03:00:23
ksamps01 I was able to use my jumper t16 running OpenTx with the multi protocol module. If you have the multiprotocol module you should be fine.
2020-08-03 11:58:39 Helpful (0)
Sezai Mahmud Hepsev can you also connect it to taranis x7?
2020-07-09 02:57:18 Helpful (1)
We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
