raymor
Q: can flash the "Arducopter Ardupilot" firmware on it?
Asked by aLDimeTech on 2021-09-07 12:49:13
raymor One of the reviews said they put Ardupilot on it and it worked well. I think Painless 360 did as well.
2021-11-22 10:39:40 Helpful (0)
raymor No. For a dead cat frame, the front arms (where the camera is) would be almost straight across. That is, the motors would not be in front of the camera, but rather beside it, so that the camera couldn't see the props. It's not *quite* a true X , but pretty darn close.
2021-11-04 12:20:53 Helpful (0)
raymor The problem with hot glue is that it melts when it gets hot. This vtx gets hot, so it may melt the glue.
2021-10-02 06:10:10 Helpful (0)Q: Which style RX antenna suits this IPEX antenna best?
Asked by okisub on 2017-11-20 12:39:48
raymor Because this antenna is straight linear) it should be paired with a straight aka linear antenna. A linear patch antenna is also okay - if you don't fly above or behind the transmitter.
2021-10-02 06:08:01 Helpful (0)
Q: will this work with raspberry Pi 3 A+. if i get 2 will this give me 64 outputs ?
Asked by Jo9t64 on 2019-02-22 11:38:34
raymor You can plug as many modules as you want into each other. That will give you 64 outputs or 128 or as many as you want. It appears that the output enable pin (OE) is connected to ground, so outputs may may high or low when the board powers up, until you shift data in. This is a design defect. The OE pin and CLR pin should have brought out so you can connect to them. Since OE is grounded and CLR isn't available, outputs may be in any unpredictable state until you shift some data in. They should have been connected to the header and a a pull-up resistor.
2019-03-15 12:06:04 Helpful (0)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
raymor Inavsupport was added some time ago.