canaverdejose
Q: Is this driver suitable for 24vdc pulse signals? ?
Asked by BG224844146 on 2021-06-04 03:37:58
Q: Can it control speed of 12v 775 motor ?
Asked by BG521161885 on 2021-03-24 01:29:45
canaverdejose No, lt cannot by itself. The motor uses 15 Amp and this module can only deliver 3 Amp.
2021-03-24 02:24:47 Helpful (0)Q: Can I switch 220V approx. 3A with this device without any problems?
Asked by lonelytrapper on 2021-03-14 11:46:44
canaverdejose The relays are rated @ 20 A 125 VAC, However, if the load is not too inductive, it can switch 220 VAC 3A, but lifetime of the relays will be reduced.
2021-03-14 03:37:29 Helpful (1)Q: the two phase means 0 and 180 phase angle output?
Asked by pdsburg on 2021-02-24 01:29:38
canaverdejose Two phase means 2 coils on the stator. Coil A and coil B. A two phase bipolar motor has 2 groups of coils. A 4 phase unipolar motor has 4. A 2-phase bipolar motor will have 4 wires - 2 for each phase. Some motors come with flexible wiring that allows you to run the motor as either bipolar or unipolar. Bipolar motors have a single winding per phase. The current in a winding needs to be reversed in order to reverse a magnetic pole, so the driving circuit must be more complicated, typically with an H-bridge arrangement (however there are several off-the-shelf driver chips available to make this a simple affair). There are two leads per phase, none is common. A typical driving pattern for a two coil bipolar stepper motor would be: A+ B+ A− B−. I.e. drive coil A with positive current, then remove current from coil A; then drive coil B with positive current, then remove current from coil B; then drive coil A with negative current (flipping polarity by switching the wires e.g. with an H bridge), then remove current from coil A; then drive coil B with negative current (again flipping polarity same as coil A); the cycle is complete and begins anew.
2021-02-24 04:47:39 Helpful (2)
Q: How far do I have to turn it to fully open/close?
Asked by Pascal on 2021-01-20 07:56:35
canaverdejose About 3 turns.
2021-01-20 03:01:00 Helpful (0)Q: Do the set contains power cable and adapter? If it is not, what type needed?
Asked by BG394939233 on 2020-10-19 03:28:36
canaverdejose The set DOES NOT come with a power adaptor. Use a power adapter of 15 to 24 V capable of delivering up to 2 Amps
2020-10-19 04:36:54 Helpful (1)
We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
canaverdejose It is marked on the enclosure: 5 V. However, 24 V volts can be cut down to 5 V via a resistor voltage divider.
2021-06-04 07:20:27 Helpful (1)