SubhrajeetSheet
Q: Will it provide 5.1 output for (stereo)aux input?
Asked by SubhrajeetSheet on 2021-09-05 06:16:17
Q: Will I get 5.1 output from it if aux(2 channel input) input is provided??
Asked by SubhrajeetSheet on 2021-09-05 06:17:18
Parbhat No u can not get 5.1 channel from single aux
2021-11-15 08:51:14 Helpful (1)Q: Requirements: 12-24v/5a and above. QUESTION IS: Can I use 12v-3.7 amp?
Asked by BG191151747 on 2021-11-18 11:14:13
SubhrajeetSheet Yes it's fine if you are to use 3 or 4 inch speakers only. If you want to connect bigger speakers(say 6 to 8 inch) then definitely you have to provide more power to it like 18 to 20v atleast 5a
2021-11-18 11:48:43 Helpful (2)Q: Does this also have the awful "the bluetooth device is ready to pair" voice prompts, or not?
Asked by rjscosta on 2020-10-11 05:23:57
SubhrajeetSheet No, it makes a small tone which is similar to that of iPhone.
2021-11-18 11:42:10 Helpful (0)
Q: What is the frequency range of the right and left speaker output? Thank you
Asked by BG144854246 on 2021-07-12 10:13:33
SubhrajeetSheet 0 to 15000Hz or above.I tested on Woofers and mid-range speakers and it came out to be upto 15kHz. I don't have tweeters, they have higher frequency response capability so may be it can produce sound more than human hearing capability i.e. 20,000Hz
2021-09-09 04:36:28 Helpful (0)
SubhrajeetSheet 100w channel is dedicated to subwoofer so mid range speaker will not produce enough sound. As I get from your question If you have enough electronics knowledge you can modify the amplifier board according to your requirements by removing 5532IC(which is used for filtering) but it wouldn't be worthy as almost all components are SMDs
2021-09-09 04:10:05 Helpful (0)
SubhrajeetSheet RMS
2021-09-09 04:03:42 Helpful (0)Q: Can i connect a 40volt(34volt) solar panel into input ?
Asked by Edmorro on 2020-12-14 02:04:21
SubhrajeetSheet It depends on your purpose of use. Just remember it's a boost converter. whatever input you provide output voltage will be higher only. and always remember Power= Volt × Ampere.So increased voltage will have lower Ampere in output.
2021-09-09 04:03:08 Helpful (0)Q: posso usar uma fonte de 24volts e 10 amperes?
Asked by adalbertos on 2021-06-14 02:03:38
SubhrajeetSheet Without any issue make sure there is nominal ripple in your power output
2021-08-29 02:14:52 Helpful (0)
SubhrajeetSheet It will definitely work without an issue but you will not get that much output power as your subwoofer is capable of.
2021-08-29 02:13:33 Helpful (0)Q: Can I use in stereo mode, without turning on the Sub?
Asked by RoZelo on 2021-04-30 04:49:56
SubhrajeetSheet there is separate control knob for bass just decrease it to minimum.
2021-08-29 02:11:20 Helpful (0)
SubhrajeetSheet Get a local Bluetooth FM module that comes with remote and connect that module's output to this amplifier's aux input. It may solve your problem. But remember always connect to that module's Bluetooth and not to this amplifier's Bluetooth or your remote will work but not affect.
2021-08-29 02:10:01 Helpful (0)Q: Hello can you use a 32V 5A DC supply ?
Asked by raki_r on 2021-06-16 09:25:19
SubhrajeetSheet It will fry the components don't do this. Just decrease the voltage using some voltage regulator or DC DC buck converter
2021-08-29 02:04:05 Helpful (0)
SubhrajeetSheet A connector is provided with this other than this normal DC connector can be used
2021-08-29 02:01:40 Helpful (0)
SubhrajeetSheet It depends on what speaker you are trying to drive through this amplifier. If you use small 3-4 inch speakers then 12v power supply is sufficient if you use bigger speakers you must provide higher power supply say 18v or even higher. Remember If you provide more than 15v power supply don't increase volume more than 70% for 3-4 inch speakers or your speakers may burn.
2021-08-29 01:59:22 Helpful (1)Q: is there an audible beep/notification sound or a voice for the bluetooth connection?
Asked by camo1089 on 2020-10-20 04:07:25
SubhrajeetSheet just a simple short musical sound no voice of saying bluetooth mode or connected or something like that
2021-08-29 01:53:37 Helpful (0)Q: what is main speaker ohms and L&R speaker ohms
Asked by BG185315162 on 2020-08-05 03:34:21
SubhrajeetSheet for each channel 4 to 8 ohm is recommended. so don't use outside the range for safety.
2021-08-29 01:42:43 Helpful (0)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
Cool Stuff yes
2022-03-31 09:09:54 Helpful (0)