sharptrack2
- My Contents
- All Messages
- Reviews
- Comments
- Answers
- Questions
Answers
Q: Essa extrusora é compatível com a impressora Anycubic Kobra Go ?
Asked by BG104611571 on 2023-01-11 14:32:42
sharptrack2 Dependson the size of the threads in your hotend, but typically they will work.
Helpful (0)
Q: Is 8 MB PSRAM the same as 8 MB flash memory?
Asked by JPe2 on 2023-01-05 07:08:49
sharptrack2 Yes
Helpful (0)
Q: Hello, how much waterproof is the lazer? can I use it while swimming or diving?
Asked by BG405757361 on 2021-11-26 14:28:27
sharptrack2 No,not waterproof.
Helpful (0)
Q: My PCB has two solder pads marked J3. what is that for?
Asked by Dolon on 2022-10-01 06:43:09
sharptrack2 Look at the schematic diagram that came with the kit. It shows that J3 is an extension of J1. It would allow you to daisy chain multiple boards or power 2 devices simultaneously.
Helpful (2)
Q: is there a diagram of the connections to arduino?
Asked by McNamara on 2022-06-01 11:25:55
sharptrack2 No,you need to have some basic understanding of what the module outputs to determine what pins to use on your Arduino board.
Helpful (0)
Q: Is this an official Creality upgrade kit?
Asked by Tom S on 2022-04-21 16:29:33
sharptrack2 Yes, and is easy to install. No guesswork what so ever.
Helpful (0)
Q: how many kilograms the roll
Asked by ID7MI1 on 2022-04-02 12:06:17
sharptrack2 The "1KG" in the description defines the total weight of filament on the roll. The "1.75MM" defines the diameter of the filament.
Helpful (0)
sharptrack2 Probablynot. The mounting points will most likely be different. If you're handy with modifications though you could make it fit and it should work fine.
Helpful (0)