parajared
- My Contents
- All Messages
- Reviews
- Comments
- Answers
- Questions
Answers
Q: What are the 4 wires? Can we get some labels on them?
Asked by RTE on 2019-02-04 09:28:07
Q: is correct the wiring in the picture?
Asked by zippomaker on 2018-10-05 15:41:53
parajared No! I had some major headache factor trying to figure out why the miserable GPS wasn't working. The TX and RX wires are backwards.
Helpful (0)
Q: Can you use this with Eachine Wizard x220s? is there an associated android app?
Asked by Brabus77 on 2019-04-07 12:47:58
parajared not without replacing the entire Wizard x220 flight controller board
Helpful (0)
parajared If it's the same as the Chanzon chip then it's 30x30mm
Helpful (0)
Q: Can I use it with eachine TX03?
Asked by vito80 on 2018-11-15 16:40:18
parajared yes, any analog signal
Helpful (0)
parajared I hope this finds someone. The software doesn't "flip" unfortunately. You have to remove the screws holding the camera back-plate and flip the camera mount, drill holes in the backside of the mount (exact opposite of where it initially mounted on the front) then put the screws in the new holes. re-balance the camera by sliding it left-right until it hangs dead-center.
Helpful (0)
Q: 4s
Asked by Anonhi on 2018-05-14 17:03:39
parajared 1300-1800mah. It will spike over 120amps for less than half a second so consider getting a C rated battery that matches accordingly.
Helpful (0)
Q: this is the new version or you must buy the new dvr?
Asked by antoine rebollo on 2018-08-08 08:06:51
parajared its the new version with the upgraded caps and DVR
Helpful (0)
parajared Can I just chop them off?
Helpful (1)