Goober
Q: is the camera good for a 4” crocodile baby?
Asked by BG143216164 on 2021-03-04 09:17:36
Goober it’s neither, really. but closer to the V4 than the V5. But there are numerous issues - the biggest being that the arms are 5mm not 6mm as he original build spec demands. It’s a big build that’s meant to swing 7” props - 6mm arms is important, i think.
2020-09-30 08:00:55 Helpful (4)
RcCharly I plugged in balance leads backwards like 100 times, works like a charm.
2020-04-30 04:52:53 Helpful (1)Q: Any LED pin available? Pin for smart audio or other uart?
Asked by MilanSpacek on 2019-01-13 03:33:56
Goober yeahhhhhhhh this board died on my too within a few packs. smoked a motor too - the fets don’t seem rated either for the voltage or the amps. i was using 2s and 0802 12000kv 40mm props. should’ve been TOTALLY fine.
2019-02-03 11:13:17 Helpful (0)Q: Can anyone answer the buzzer pad question? It's a deal breaker for me if there isn't one.
Asked by Glenn Vorhes on 2019-01-25 09:37:16
Goober doesn’t have a buzzer pad - but dshot beacon should work if that’s loud enough.
2019-02-02 12:21:15 Helpful (0)Q: What board do I pick when flashing Betaflight?
Asked by Jim Morrison on 2019-01-12 01:47:45
Goober Mine says the target is "NOX"
2019-01-28 04:20:55 Helpful (0)
Goober All the pads are labeled though... across the top: GND, 5V, VOUT, VIN across the bottom 3V, (DSM, etc), SBUS, 5V, GND. Page says RX2 for RC control. So.. no TX, No buzzer, No SA... which is pretty silly. But it’s 25% the cost of others. so priorities, i guess.
2019-01-20 07:04:57 Helpful (0)Q: they could DO IT BETTER!!! add current pin instead of Ground pin near leds out!
Asked by frimen on 2019-01-07 05:51:04
Goober current!? what is this ancient analogue technology you speak of?? Get with the times and get an ESC that supports telemetry. I’m really kidding though - you bring up a great point. regardless this would be a HARD PASS for me. ICM gyro on a micro sized FC with no integrated softmounts? We kinda ran this experiment already the wave of ICM gyro equipped FC that were universally panned as being impossible to tune without integrated soft mounts / grommets.
2019-01-07 07:10:43 Helpful (0)Q: Will you be selling the frame and spare parts separately?
Asked by Goober on 2018-11-15 06:51:17
Conciliabule Yes, will sell the empty frame next week
2018-11-27 03:57:30 Helpful (0)Q: are you supposed to be able to snap off the two long legs? is that what the dotted lines are for?
Asked by Goober on 2018-10-16 08:02:10
Marconius Haaaaaaaaaa!!!!!!!!!!!
2018-10-30 03:08:57 Helpful (0)
Goober It's a Blheli_S ESC - BLHELI_32 should not work. Sounds like you might have the buzzer configured wrong.
enagano I would like to know if the original alien pdb will work?
2018-09-03 06:26:49 Helpful (0)Q: what does the buck boost do exactly?
Asked by nonickjustname on 2018-07-20 09:22:03
Goober Buck boost is a type of voltage regulator. Buck boost regulators are usually much more reliable than the alternative, which is a linear regulator (they’re usually cheaper). I’ve heard that the regulator on this board though is best suited to ~25mw VTX’s. If you’re going to run ~200mw you may need a separate regulator. Just what I’ve heard. No experience personally.
2018-08-10 10:14:43 Helpful (1)Q: How can the 6" be 3g lighter then the 5"?
Asked by Emil79 on 2018-06-23 03:43:40
Goober looks like they weighed it without the PDB and accessories - for the 5” this was all included in the weight
2018-07-01 02:15:20 Helpful (0)Q: Planned release date? This looks amazing!
Asked by Goober on 2018-01-25 07:06:02
Lanny Hello, it is expected to be stock at the beginning of March.
2018-02-05 03:47:08 Helpful (0)
Goober The images shown here are not of the actual product. They are of the product that is being cloned by PUDA. You can see those image on the original manufacture's site: https://xhover.com/products/xhover-stingy-pre-order FWIW the PUDA is available elsewhere, it likely has press nuts (not embedded nuts), the reinforced plate for the cam may or may not come with it, the hardware will almost definitely NOT be titanium. etc... etc...
2017-12-02 10:05:00 Helpful (2)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
Goober The GEPRC Crocodile Baby 4 Analog appears to come with the Caddx Ratel, which is 19mm cam - the Ratel 2 is the same width - so it really should fit just fine.
2021-03-04 09:24:27 Helpful (3)