All Messages

MarkusP 05/10/2021
Ordered Monday, 27.09.2021 on banggood, Warehouse Spain, and delivered an Friday, 01.10.2021, to Germany. This is super fast - 5 Stars for this. The package / carton was damaged at several points, but the printer itself (all parts) are in fine condition - 3 stars It was easy to assemble the printer, took me 20 minutes from opening the package, checking all parts are there to switching the printer on and starting the first/initial leveling - 5 stars Whats not so good is, that the frame has signs of use - so I am not sure if this isnt a reselled but used printer, a former customer sends back to creality, where only the small parts like screws and the filament are replaced - 3 stars Started a print, with the sample PLA roll, of a low poly figure (nearly 25cm tall) from the SD-Card. The print took nearly 24h and after 18h the sample roll run out of material and I had to change filament with a new PLA roll. Everything work, firmware detected the out-of-material and roll change and reloading the filament worked easily out. Resume of print worked fine - 5 stars The printer is medium loud. compared to my former Creality CR-10 S Pro it is silent. Compared to my Prusa i3 MK3S it is loud :) I am sitting beneath this printer for hours now in my office and it is no prob to work, the sound is not to annoying - 4 stars All over the printer works fine and is woth its money. Now I will try to find out what I can tweak to make it more silent. Even will switch the firmware to custom and print some enhancements.
2
Recommendations
Comments (0)