All Messages

reyalp 21/04/2020
Very good quadcopter! Stock betaflight 3.5.1 is not very good so i flashed 4.1.5 with FuryF4OSD (DIATONE) as target. Flashed the esc with jazzmaveric 96khz and a little fiddle with Albert Kim's pids and it flies good. not perfect as i have a little wobble when throttling down after hard punches. Im gonna put some more packs into it this week amd get it 100%. I used Albert Kim's settings for the Caddx turtlev2 and the footage i get is AMAZING! if it were not for the lens distortion at the egdes i would say no need for gopro anymore. The were things i did not like: stock vtx dipole antenna .( swapped it with lumenier axii2 hotglued to the top rear after drilling small hole in the recessed two holes.) the stock rx antenna mounts. (i used zipties from the rear arms and heatshrink to fasten them. ) did not like the exposed motor screws. ( added liquid electrical tape. rich amount in two go's to make pads that cover the screws). the lens is made of plastic with no nd filter. Ordered the glass turbo lens and nd filters to remedy this. they are now instock and have been processed and shipped. cant wait for them to arrive so i can test them out. afterthoughts. this drone is really REALLY fast. be careful as you WILL exeed 170 kmht at full throttle and keep an eye on the rx signal as you quickly run out of space with this one. outside flying recommended 👌 i will set a profile with throttlelimit for park flying as it has an ample amount of thrust. and when i ample i should say insane instead. what a beast! its waaay faster than my 5 inch with 2306 2600kv on 32 bit aikon's and 4s. handling is a bit choppy though but i can remedy that with rates and configs. get this bird if u want a fast one.. frame is super stiff too.
1
Recommendations
Comments (0)