All Messages

Tom 2020-08-21 16:32:59
0
Recommendations
Comments (0)

Top reviewers you may like:

Tom 2020-06-02 06:16:45
0
Recommendations
Comments (0)

Top reviewers you may like:

Tom 2019-09-14 07:13:35
0
Recommendations
Comments (0)

Top reviewers you may like:

tom_pascoe1135 Yes, Use the breakout board and the 0-10v PWM channel.

2019-04-09 06:35:30 Helpful (0)
Submit
Answers (2)

Confiteor I asked them and they told me they would have it restock asap.

2019-03-31 10:30:28 Helpful (0)
Submit
Answers (1)

Q: What is the bolt holes on the underside? M8?

Asked by tom_pascoe1135 on 2019-03-15 02:38:04

Michald It is M6X1

2019-03-17 10:54:04 Helpful (0)
Submit
Answers (1)

TomPasco This is not a drive gear. These teeth are for pushing filament not for driving a belt. These teeth pitch will just be a knurl finish

2018-03-22 08:19:48 Helpful (0)
Submit
Answers (2)