Customer Reviews

5 out of 5
See all 6 reviews
Write a Review
  • All Reviews (6)
  • Image (3)
  • Video (0)
  • All Star
    • All Star(6)
    • 5 Star(6)
    • 4 Star(0)
    • 3 Star(0)
    • 2 Star(0)
    • 1 Star(0)
Sort by:
Top Review
  • Top Review
  • Most Helpful
  • Most Recent
Reviews only from your country (India)
|
Show Original

A part of the review has been auto-translated.

  • 21/05/2019

    As far as upgrades are concerned, I cannot see any difference between the original and this one. That aside, this is a cheap way to get into 32bit boards while using the still ubiquitous RAMPS. The board is of high quality. However this board(including the original from Panucatt) has a few shortcomings compared to the mega. 1. Few less pins than mega 2. SPI mode with TMC2208 drivers 3. Using the RepRap Discount Graphics LCD There's a hack to get the LCD working, by getting 5V from some other pin. I'd say this is not intended for absolute beginners. Smoothieware comes preloaded. With some steps marlin(v2.0) may also be installed. It's easy to upload firmware to this board using the SD card that is included. Despite some hassle, it's a cheap way to really UPGRADE an older printer board!

    Comments
    Show Original
  • 21/03/2019

    Easy upgrade if you already have a RAMPS board and you want to switch to 32-bit without making to much changes to your setup. Package arrived nicely packaged, includes a USB mini cable and MicroSD-card. On said MicroSD you get Smoothieware preloaded but you could also run Marlin 32-bit instead (Marlin has a special version for this board ) Quality is ok, not perfect soldering but well above what I expected! Might order more to keep as spares

    Comments
    Show Original
  • 19/06/2019

    works perfectly fine , also came with a 128 MB sdcard to hold the operating system and eeprom files

    Comments
    Show Original
  • 28/10/2019

    Alles OK.

    Comments
    Show Original
  • 24/06/2019

    Product as described. I do recommend.

    Comments
    Show Original
  • 09/05/2019

    Precisely what I ordered. Already working in my printer, straight swap with Arduino, just logic levels with inductive sensor was a bit of a problem.

    Comments
    Show Original
Show:

    Total 0 pages

    Go to page

    Go
    recommendation for you
    • ₹154.87
    • ₹546.21
    • ₹665.28
    • ₹415.49
    • ₹2,913.41
    • ₹142.38
    • ₹24,895.99
    • ₹33,222.40
    • ₹332.22
    • ₹1,497.92
    • ₹5,411.34
    • ₹2,497.09
    • ₹1,248.13