Customer Reviews

4.75 out of 5
See all 4 reviews
Write a Review
  • All Reviews (4)
  • Image (2)
  • Video (0)
  • All Star
    • All Star(4)
    • 5 Star(3)
    • 4 Star(1)
    • 3 Star(0)
    • 2 Star(0)
    • 1 Star(0)
Sort by:
Top Review
  • Top Review
  • Most Helpful
  • Most Recent
Reviews only from your country (India)
|
Show Original

A part of the review has been auto-translated.

  • 07/06/2020

    You're here pretty fast, 👌 I'm still in the assembly phase, so I haven't tried it yet! But everything seems to be okay, 👍 I recommend 🙏👌👍

    Comments
    Show Original
  • 19/05/2020

    Quick delivery, everthing ok

    Comments
    Show Original
  • 27/04/2020

    Good product, good quality, best price. A bit inaccurate assembly instructions but otherwise everything is fine. I adjusted to a 1mm nozzle and there is no problem with leveling.

    Comments
    Show Original
  • 16/06/2020

    good machine, some defects necessarily for a machine but adjusts quite easily. improvements not noted: - 24V power supply and 24V heating mats, apparently the old versions were with 12V power supply and heated in 1h. Heats quite quickly, printing possible after 10 minutes maximum. - automatic bed adjustment - all supports except those of the x and y engines in steel (bigger apparently unlike the old ones in acrylic) - steel coil support (to be seen if 1kg coils are accepted, pending delivery for the moment) - the belts do not cross any more and are fairly well adjusted, for the maniacs one can still adjust by adding washers to center the whole, there is still a displacement on board but it seems to go because the impression is of good quality) some improvements to see: - carpet delivered with is not accepted by the sensor, I print on the fiberglass plate and it works. - mounting the engines on silent block for the x and y axes because they resonate in the chassis, it's quite noisy. - the location of the clamps is bad because the nozzle comes to type in during the calibration but does not disturb it in any way for this one. - to facilitate the passage of stl files in gcode I advise to use Cura because I did not manage to do it with the Rapetier software. - The chain of the heating carpet was to be reduced by 3 links on mine because too long. - It would be necessary to make a support to support the chain of the printing head because it comes to rub on the belts in certain positions and to take the flexible that goes from the extruder to the head because with the length it is put any way during the printing. - A rail should be made for the tablecloth that connects the control box to the module located at the rear of the machine because it holds only by the sockets.

    Comments
    Show Original
Show:

    Total 0 pages

    Go to page

    Go
    recommendation for you
    • ₹998.34
    • ₹748.54
    • ₹41,090.04
    • ₹748.54
    • ₹2,996.68
    • ₹5,744.40
    • ₹1,997.51
    • ₹415.49
    • ₹2,913.41
    • ₹142.38
    • ₹33,222.40
    • ₹24,895.99
    • ₹332.22
    • ₹425.48
    • ₹1,497.92
    • ₹5,411.34
    • ₹2,794.35