Storm32BGC 32-bit Brushless Gimbal Control Board With MPU6050 Sensor for RC Drone FPV Racing
A part of the review has been auto-translated.
the rx and tx are marked the wrong way around in rc in the pick here. Go to http://www.olliw.eu/storm32bgc-wiki/Getting_Started for correct pins for this v1.3 board. My led next to reset and boot did not work, but i was able to flash it still with v0.7 firmwear. i also had to check the perform full chip erase box in the o323BGCTool_v080 to get it to flash. i flashed with one of these http://www.banggood.com/FT232RL-FTDI-USB-To-TTL-Serial-Converter-Adapter-Module-For-Arduino-p-917226.html then used the o323BGCTool_v070 for the Configuration & Calibration though the usb on the board
Hallo Das Gehäuse passt nicht! Alle Öffnungen müssen nachgearbeitet werden. Angeschlossen an 12 Volt und schon die ersten Rauchzeichen, Mosfet ist abgebrannt. Spannungswandler defekt. Zu wenig Pins! Banggood stellt sich quer mir ein neues zu schicken, Video und Bilder sind zugeschickt. Hinhalten und wieder fragen nach Videos.
ho ricevuto la scheda storm 32,,senza nessuna istruzione all'interno!!! praticamente dopo 2 settimane ancora non ho capito come fare ,,se l'alimento non si muove ,per gli aggiornamenti non so dove mettere le mani,,,delusione totale!!,,vorrei tanto distruggerla !!!
Seems to work fine , after passing 1 hour searching for the correct GUI version 2.11e NT , witch you can find only on RC Groups http://www.olliw.eu/downloads/storm3...-v20160808.zip
after struggling with the 8 bit boards i decided to buy this 32 bit sucker. boy what a great move that was! thanks banggood for the cheap price!
un buon prodotto, un po' complicato in fase di settaggio ma molto buono, bisogna solamente perderci del tempo
The board comes with plastic box, sensor (with his box) and a cable for the sensor. It appears clean and well built. No connectors are provided to connect motors and other interfaces, neither the one for the sensor: you must buy them separately. The board has firmware version 0.83: you must buy a RS232 to USB cable to upload an updated release of the firmware.
Board comes with a case, and so does the IMU. Would be better with a shielded 3 core cable and a connector on the IMU rather than a soldered point. Would be better if the kit supplied more pin connectors for extras.
Grateful if Banggod could advise whether your shop could provide the Storm32 gimbal tuning and configuration software. Or, could Banggod provide the link to download the tuning and configuration software. Many thanks!
A good product