JST PH2.0 Plug 1S Parallel Charging Board XT60 Input for Battery Charger
A part of the review has been auto-translated.
Nice little board to parallel charge your little 1s batteries using PH2.0 or 1.25 connectors between each connection is a fuse (I think) / diode it has a green Led when powered and comes with an xt60 and 4mm banana plug depending on the charger you want to use it with. Very useful to storage charge your 1s lipos on your main charger or to charge multiple batteries together
Not real xt60s and the wires where not soldered in the through holes. Solder paste was left all over the board. Really bad quality. But the board works and is cheap. If you don't mind the low quality or don't mind fixing it up with a little soldering and rubbing alcohol. Then this is a buy for you. Also not the board itself is really nice. Thick copper traces so no problem with the board burning out.
Great charging card for type 1s. use with ISDT 300 PRO to recharge the type of the tinyhawk and it works well.
very good
Bought my 1S batteries to discharge and keep them in storage mode. You can charge or discharge as much as a total ampere as 1S by turning off balance mode from balancing chargers
I thought there was a little led light next to all sockets but no. It's only one at the top.
Good quality product as advertised
Works like a charm, came in 2 weeks, great product
Great service ..delivery in 10 days ..I recommend the seller for the seriousness
Useful little board for parallel charging 1S lipos. Always make sure the batteries all have the same voltage before connecting them with this board.