High Power 10W LED SMD Chip Bulb with Waterproof Driver Supply DC9-12V
A part of the review has been auto-translated.
I have received this product today through china post. overall its a great product
Saved £13 by replacing the LED and power supply in a PIR LED lamp. This required two soldered joints for the LED, with mains connections by screw terminals. Make a careful note of which goes where before removing the duff components. The LED tags are marked with polarity (Red = +) Remember to add a smear of heat sink compound on the rear of the LED before mounting. Pictures show: The new LED installed. note the sleeving is re-used: it's important the reflector cannot touch the tags. The new power supply installed. You may have to drill new fixing holes to suit. The PIR wires are yet to be connected (if it has one).
Wszystko jak należy, driver działa i dioda świeci :)
funktioniert sehr gut, die LED ist sehr hell. Leider wird die LED sehr heiß und es sollte ein Kühlkörper angebracht werden. (Auf dem Foto sieht man einen von mir angebracht) auf dem Treiber ist rot und schwarz vertauscht aber die Farben der Kabel stimmen. zufrieden mit der Qualität
Not as described. Led driver only gives 5watt. I measured output voltage at 10.4vdc and output current at 450ma. Even at 5 watt the led is too hot to touch after 5 seconds so considerable heat sink will be required to avoid cooking chip. It would be helpful if this was indicated.
10 days later than the others but at least they are here ! Everything works fine, thanks.
good product end shipment, thanks!
Good, good!!!! Thank's!
Brilliant service delivery will buy again
bom produto