A part of the review has been auto-translated.
Good quality, great for experimenting with non-planar printing, wire mode in Cura and keeping the heat block away from the prints (helps get better details in small precise prints)
I've been using them for about 2 weeks now and I have to say I'm kinda impressed with the performance, one thing I did realize is I had to print 5°c hotter on the hot end because of the ss tip but other than that they are pretty good
seems to work fine and appears of good quality, however I am getting stringing more and walls seem to be less adhered with prints also being slightly more brittle due to the lower heat. will try out more settings and give a better rating if there's improvement.
actually looks very good - - - only as it is small and not the best at keeping a clean office - - - area - - - I lost it - - - it should show up someday
amasing but seriously could have been send with previos 0.3 order this was some how split in to two the 0.3 and the 0.4 I meen the cost is just outragious by splinting an order
nozzles came in quickly, and seem to be well made. I will be glad to post more once I've had a chance to try them out
This nozzle seems well made. The hotend I bought had one installed already, so I haven't used it to yet.
Have not tested it yet buit really looking forward to it. I hope it will help in very small details printing
very prompt!
Great item.