With my new probes, measuring SMD compassants becomes easier, but it takes hands and therefore no photos. This clamp is well made because I can easily measure on a finished circuit to control a component, or even easier to I sort out the components placed on a work surface and start searching for the desired SMD. The measurement is easier, I have one hand left to take the photos for proof! Only one small drawback, the clamp is hard to tighten the end on the SMD. After a quarter of an hour ... the cramp. By slightly bending the final electrodes of the clamp, you're done ... But with pressure when tightening when measuring. Perfect here photos with an SMD resistor marked 103 or 10Kohms. I tested one at a friend's house, I quickly understood the interest in I bought 5 in total!

With my new probes, measuring SMD compassants becomes easier, but it takes hands and therefore no photos. This clamp is well made because I can easily measure on a finished circuit to control a component, or even easier to I sort out the components placed on a work surface and start searching for the desired SMD. The measurement is easier, I have one hand left to take the photos for proof! Only one small drawback, the clamp is hard to tighten the end on the SMD. After a quarter of an hour ... the cramp. By slightly bending the final electrodes of the clamp, you're done ... But with pressure when tightening when measuring. Perfect here photos with an SMD resistor marked 103 or 10Kohms. I tested one at a friend's house, I quickly understood the interest in I bought 5 in total!

With my new probes, measuring SMD compassants becomes easier, but it takes hands and therefore no photos. This clamp is well made because I can easily measure on a finished circuit to control a component, or even easier to I sort out the components placed on a work surface and start searching for the desired SMD. The measurement is easier, I have one hand left to take the photos for proof! Only one small drawback, the clamp is hard to tighten the end on the SMD. After a quarter of an hour ... the cramp. By slightly bending the final electrodes of the clamp, you're done ... But with pressure when tightening when measuring. Perfect here photos with an SMD resistor marked 103 or 10Kohms. I tested one at a friend's house, I quickly understood the interest in I bought 5 in total!

ok

ok

ok

very good product

très bon produit

very good product

Good value for the price, they would benefit from a sharper point to break through the oxide layer.

Good value for the price, they would benefit from a sharper point to break through the oxide layer.

Good value for the price, they would benefit from a sharper point to break through the oxide layer.

Received this order and I tested it out and looks good and works great. Thanks Fabio

Received this order and I tested it out and looks good and works great. Thanks Fabio

Received this order and I tested it out and looks good and works great. Thanks Fabio

ok

ok

ok