50pcs 5X10cm Single Side Copper Prototype Paper PCB Breadboard 2-3-5 Joint Hole
A part of the review has been auto-translated.
Thanks very much the goods arrived full without shortage on 6-3-2018
Good quality material..
sehr gute Qualität
Pratique pour faire des cartes rapidement. Quelques court circuit entre les pistes sur certaines cartes et des trous de perçage parfois un peu mal fait. Mais pour le prix rien à dire.
ok
Very useful protoboards. Save lot of time soldering as it is the same layout as a breadboard. The copper layer is very decent; covered with heat reactive enamel making soldering very easy (copper is very clean and not oxidized, so very prone to react properly with tin) . A very good point. Be aware that, sometimes, some tracks are connected because engraving is very thin, but it is ok and provides tracks that are wide enough to support high currents, if not at least high tension. A close inspection before using it is a good warranty of not searching why your design is not reacting as it should. But for hobby electronic with low tensions, it is perfect..
Solder sticks well to the copper. Over half of the boards had slight flaws such as one or more holes drilled too large but this wasn't serious enough to make the boards unusable. That said, these are a good value for the money.
This is my favourite PCB for small electronic prototype circuitry.
This is a well made and well designed PC board for building and testing small electronic circuits.
Produto de alta qualidade com preço interessante.