3Pcs DIY NANO IO Shield V1.O Expansion Board
A part of the review has been auto-translated.
A very useful board to hold Arduino Nano and for providing wired access to Arduino pins. A LOT of careful soldering required. Recommend you place the 5 wire devices together BEFORE soldering to board. They have a sliding lock on each side, and they will not easily fit if you solder them in individually. Also, make sure the Nano sockets are at 90 degrees to the board, and spaced to holed an Arduino Nano. It is a good idea to use an assembled Arduino to make sure this is achieved - place sockets on the Nano and then place in board with Nano before soldering., and recommend you do this BEFORE attaching wired sockets.
muy buen acabado profecional
Quality board and components, very easy to solder due to the quality of the board.
Arduino Nano has just 4x 1,5mm holes for mounting but who has M1,5 screws?? :D :D :D :D This expansion board help that problem. Maximum 30 minutes soldering. Caution! The mother pins must be paralell for light connecting the Nano board!
Excellent with long terminal.
The letters and numbers on the board are printed as mirror low quality
Good items, very fast shipping
Assemblaggio facile e veloce se vi posso dare un consiglio saldate i strip con Arduino nano inserito
Ottimo prodotto, conforme alla descrizione
correct